/FF/ N54 Billet Intake Manifold

A4RingedONE8T

Specialist
Nov 1, 2016
82
134
0
40
Just wanted to share the final revisions on our intake manifold. First production manifold will be leaving to Tony in the next day or two for his manifold testing. Updated and tweaked a few more things, moved it up to our larger plenum as it seems everyone thinks this engine needs a larger volume. Pulled a little more weight out of the plenum and gave it it's finishing touches and vac connections. Fuel Rail finalized and perfectly fitting around stock rail. My first batch of manifolds are already sold but have more billet coming tomorrow morning to start another 10. Visit our website www.Fab-Factory.com for further info. Appreciate everyone's following
thumbupright.gif


-Shawn-

1.jpg
2.jpg
3.jpg
4.jpg
5.jpg
 
  • Like
Reactions: Jeffman and 08_335i

Rob.K

Lurker
Nov 7, 2016
15
7
0
Fort Saskatchewan
Looks great! I do have a question though, where's BOV meant to go? Or is that up to us to get fabbed?

"Requirements for installation, not included with manifold:
  1. Cold side charge pipe modification to meet new throttle body location. Use our /FF/ Throttle Body Adaptor for your fabrication needs. A 3" pipe can be welded direct, or use a 3" slip fit silicone and T-bolt connection. "
 
  • Agree
Reactions: doublespaces

Erichale77

Lieutenant
Nov 14, 2016
827
447
50
Clearwater, FL
Ride
07 E92 coupe
Looks great! I do have a question though, where's BOV meant to go? Or is that up to us to get fabbed?

"Requirements for installation, not included with manifold:
  1. Cold side charge pipe modification to meet new throttle body location. Use our /FF/ Throttle Body Adaptor for your fabrication needs. A 3" pipe can be welded direct, or use a 3" slip fit silicone and T-bolt connection. "
You will need to lengthen throttle body wiring and fab up charge pipe. Mine looks like this...IMG952946.jpg
 
  • Like
Reactions: Rob.K

Kervio

Private
Jan 7, 2017
43
15
0
Gorgeous manifold! At first glance I had to make sure it was an n54 bay without the ugly plastic manifold....
 

A4RingedONE8T

Specialist
Nov 1, 2016
82
134
0
40
Looks great! I do have a question though, where's BOV meant to go? Or is that up to us to get fabbed?

"Requirements for installation, not included with manifold:
  1. Cold side charge pipe modification to meet new throttle body location. Use our /FF/ Throttle Body Adaptor for your fabrication needs. A 3" pipe can be welded direct, or use a 3" slip fit silicone and T-bolt connection. "

BOV and map sensor will fit in the cold side charge pipe still.

That is gorgeous. Really nice piece there guys.

Thanks Chris, look forward to your comments once it's in your hands!

Gorgeous manifold! At first glance I had to make sure it was an n54 bay without the ugly plastic manifold....

I've made a few N54's not so ugly in my time =D

What about fitment with a Drivers side coolant reservoir?

Fits perfectly fine!

Here's a picture of one of my sheet plenum manifolds (same TB location as the billet version) showing the drivers side mounted coolant tank, as well as a full charge pipe - IC to TB

Eric bay.jpg
IM charge pipe.jpg