New EKPM board for short money

[martymil]

If I was running a LS swap I'd use the stock setup as a lift pump to a swirl pot and a proper setup to feed the motor to bypass
the factory rubbish.

 

[Haideezy]

I think I may pick one up. I'm so tired of my EKPM crashing. Currently running the Radium FSHT w/ 3 walbro 450s; first one being used as a pickup pump, second pump running off the ekpm, and third controlled by Reflex+. EKPM2 crashes when e-content is above 50 and the EKPM3 just totally shat itself today...

 

[Darke Peak]

If I was running a LS swap I'd use the stock setup as a lift pump to a swirl pot and a proper setup to feed the motor to bypass
the factory rubbish.

If running an LS you probably wouldn’t have the DME. But if you did still have the DME to send a Canbus signal to the EKPM it would be trying to target 72psi, resulting in the pump running 100% PWM and defeating the purpose of using the stock control system (and probably triggering fault codes)

 

[BoostedBafoon]

I've been running one without any issues. Works as advertised. I would favor setting your second pump turn on based off of torque instead of pedal position. And this does not run your secondary pump constantly.