Ad: YCW Dry-Carbon Driveshaft - Pre-Order Special
- Thread starter MFactory
- Start date
We're still working on the 335i fitments and will post up as soon as the sample(s) are ready, but as of now, we just finished this 135i sample, so looking for a tester
Is E82 N54 6MT available?
Wonder what would take to make fit 335i like would a large pumpkin be all or they're completely diff?
Before we can make any specific fitment, we need to gather at least 10-15 confirmed orders (for that fitment).
We have all the designs ready. Just waiting for people to contact us to express interest. Unfortunately, we only have a couple "per fitment", which isn't enough
We have all the designs ready. Just waiting for people to contact us to express interest. Unfortunately, we only have a couple "per fitment", which isn't enough
I have a 2008 135i AT with a full M3 rear end.
I'm not sure if the lengths would be any different. Are you still able to run the oem length driveshaft just now?
Stock Driveshaft..... well I only use it for a timeattack challenge, so weight saving and stifness should be a plus
I'm not sure either.
Rear end has been in the car for 5 years when my shop did it. Had to modify the rear half of the shaft for the m3 yoke. Still 2 piece setup.
We didn't get a chance to measure the current shaft while engine was out recently.
Will see if we can get a tape on it as the car is getting some minor mods and still on a hoist.
Let you know.
I just received my one ^^ seems like a piece of art I just had to desinfect the whole package due to some virus is going around
And I ordered stronger bushes for the rear diff, just because of bumps, to minimize the hits on it...
I just had to desinfect the whole package due to some virus is going around And I ordered stronger bushes for the rear diff, just because of bumps, to minimize the hits on it...
Similar threads
