Calling on everyone with a GFB controller, what is your settings for GAINS and Sensitivity???

[Mvaccarelli01]

Hello everyone, I got a doc race 6266 and gforce boost controller tuned by wedge.
Was wondering what is the best gains and sensitivity settings to run for spool holding boost pressure ect?

I been messing around with it looks like with increased sensitivity it will hold boost target past 6k longer with less tapering but it seems slower to spool due to boost having a staircase climbing effect in logs

increasing gains while testing seem to just hurt performance when i tried so i leave it around 10-15

what does everyone else run their settings on??

 

[DCook]

I left mine all on 0, never had an issue spooling my 6466.

 

[Mvaccarelli01]

I left mine all on 0, never had an issue spooling my 6466.

Do you have logs? Why does your taper to high in the rpm range?

 

[DCook]

Do you have logs? Why does your taper to high in the rpm range?

No i dont anymore. Motors dont last long enough or i dont remember to log unless i was doing a revision. Mine never tapered as far as i remember, held pretty level. You might have a wastegate line leaking?

 

[335is02]

Hello everyone, I got a doc race 6266 and gforce boost controller tuned by wedge.
Was wondering what is the best gains and sensitivity settings to run for spool holding boost pressure ect?

I been messing around with it looks like with increased sensitivity it will hold boost target past 6k longer with less tapering but it seems slower to spool due to boost having a staircase climbing effect in logs

increasing gains while testing seem to just hurt performance when i tried so i leave it around 10-15

what does everyone else run their settings on??

0 also I tried going up on gain couple times just to feel difference and seems smoother on 0.