Latest activity
-
You are correct. Where an upgraded oil cooler helps is above 120C, which is also where you need it. I bypassed my thermostat for a... -
That looks quite poor for a 6262. Should be spooling 600rpm earlier than that. Maybe a boost leak somewhere or a plumbing issue... -
carabuser replied to the thread Full boost @ 4450rpm ?.That looks quite poor for a 6262. Should be spooling 600rpm earlier than that. Maybe a boost leak somewhere or a plumbing issue... -
Hi, so the car is now running great, and I wanted to check if it's possible to have more low-end power with my actual setup. 4450rpm...
-
EThe emulator for retrofitting the GWS from M cars is now working pretty solidly. However, I’ll need to redesign the PCB to meet...
-
dano1107669 replied to the thread N54 starts then stalls.I tested the wires going to the fuel injectors with noid lights. The lights will flash showing that the injectors are getting power and... -
ktb_e92 replied to the thread Need help with intermittent codes/warm start issue.Another thing you could try is doing a throttle relearn through MHD. Since it happens in warm / heat soaked conditions, may be worth... -
oVeRdOsE replied to the thread DIY : PTFE line- tank to HPFP + inline fuel filter upgrade.did the fuel rail mod, 11/64'', since I had issue with fuel. (6262 st, 450lph, meth 600cc 50/50) did a log this morning. hpfp start...
-
oVeRdOsE replied to the thread 3.5 TMAP reading are off (+/- 5psi) on JB4.so some report , after 4 TMAP. 1- Continental TMAP from rockauto (the initiation of this post) ; it was defective, reading were off...
-
EE36fiend replied to the thread 2017 BMW X5 MHD Stage 2 N55 (ER Cat-less DP, VRSF Chargepipe).Hey, I am having the exact same issue and codes. Did you ever figure out what your problem was?? Any help would be appreciated.
-
Peter55 replied to the thread Very high LTFT, over 20% on two banks - Z4 35is.I've downgraded to stage 0, so I could log more precisely, you're right, I should probably start with logs... -
Jeffman reacted to ccr0ss's post in the thread N54 Solenoid Direct Injectors + Custom ECU Build with
Like.
Hello, I have been working for sometime on figuring out how to make N54-powered cars easier to own and maintain. I currently own a 2008... -
Aavi 335 n54 replied to the thread Boost drops after a few pulls.Thank you very much, you were right and indeed the problem was the boost solenoid. I did a vacuum test on them and saw that one of them...
-
Ssergio.banon replied to the thread DIY Silent Twin Plate Clutch UniClutch.Sorry should have clarified, 3 different. PTB, Atix Racing, now UniClutch
-
EEX0PIL0T replied to the thread DIY Silent Twin Plate Clutch UniClutch.You've been through 3 uniclutches? or 3 clutches total?