Latest activity
-
mikedeburgh posted the thread Mike from Switzerland looking for great chats in Introductions | New Members.Hi guys, my name is Mike, 40years old and coming from Switzerland. My main language is german and polish, but english is fine as well... -
MMoreBoost replied to the thread 3.5 TMAP reading are off (+/- 5psi) on JB4.OK good stuff š
-
Jgv replied to the thread Opensource Zf 8HP transmission controller.Off topic but as Iām new would like to know where I can find more information about the mentioned solution for 5HP24 transmission if... -
Ddesmo11 replied to the thread Half n half inlet setup.I've got the cone for now, need to do some fitting kind of stuff to get the stock airbox on...that's the plan for now
-
WIP: -
ShocknAwe replied to the thread Half n half inlet setup.Definitely try to put a box on the rear side.
-
oVeRdOsE replied to the thread 3.5 TMAP reading are off (+/- 5psi) on JB4.nah, can't be that, the external boost gauge reads fine and engine runs fine, so no residual pressure. the TMAP small sensor inside... -
Vvadonchez replied to the thread N54 DME torque limits, torque tables and torque reporting discussion.Ok thanks for your feedback. I was in sport+ mode when I made this log. My z4 make more burble with WGrattle set @0% than disabled.
-
Kethi12 replied to the thread no torque plate needed for open deck block?.No, a torque plate isn't strictly needed for an open deck block in mild or street builds, but it's highly recommended for...
-
MMoreBoost replied to the thread 3.5 TMAP reading are off (+/- 5psi) on JB4.Yes I don't know too much about single setups but make sure your blow off valve is setup correctly. It should be open at idle I believe...
-
oVeRdOsE replied to the thread 3.5 TMAP reading are off (+/- 5psi) on JB4.So ordered a 3rd one. And rockauto dont allow me to return the previous one. Part number is for a 2012 to 2016 N20 328 and it denies...
-
Peter55 replied to the thread N54 exhaust camshaft upgrade.It could be N52, it has different rocker arms, so final lift is calculated by different factor. Or regrinded N52, it has bigger base... -
carabuser replied to the thread N54 DME torque limits, torque tables and torque reporting discussion.There is some burble enabled there, the lambda readings don't go full scale for 3 seconds after letting off the accelerator. The Z4 in...
