Sharp Customs Intake Manifold

[pysical]

Thinking about getting this to get rid of my MMP Gen 1 PI rail with crappy gaskets.

Anyone had any issues with it? Says it is tested to 30 psi, but I will be running more than that. I imagine it would hold since the stock plastic one could..

https://www.ebay.com/itm/263487582153?ul_noapp=true

 

[Payam@BMS]

We have our own version with little modifications done to better the product. We use USA hardware and provide special O rings for heat and ethanol/methanol use.

http://www.burgertuning.com/N54_PORT_INJECTION_INTAKE_MANIFOLD.html

 

[pysical]

We have our own version with little modifications done to better the product. We use USA hardware and provide special O rings for heat and ethanol/methanol use.

http://www.burgertuning.com/N54_PORT_INJECTION_INTAKE_MANIFOLD.html

Does that work with LS3 style injectors? And do I need anything with it? I already have injectors and AIC.

 

[Payam@BMS]

Yes works with LS3 style injectors, I'm using LS7 injectors on my setup.

Nothing else, you're good to go.

 

[pysical]

Yes works with LS3 style injectors, I'm using LS7 injectors on my setup.

Nothing else, you're good to go.

Do you guys have these in stock now? I may or may not need one yet. Trying to figure out a trim variance between banks. Was headed towards PI rail but we will see in the next day or two hopefully.

 

[Payam@BMS]

Do you guys have these in stock now? I may or may not need one yet. Trying to figure out a trim variance between banks. Was headed towards PI rail but we will see in the next day or two hopefully.

Yes, in stock ready to ship. We've sold over 50 with all positive results.

Are you having a trim variance with DI only? Meaning no methanol etc spraying additional fuel.

 

[pysical]

Yes, in stock ready to ship. We've sold over 50 with all positive results.

Are you having a trim variance with DI only? Meaning no methanol etc spraying additional fuel.

Yeah. PI plate is installed but not hooked up. Just running 93 atm.

https://datazap.me/u/pysical/motiv-93-v2?log=1&data=2-22

Working with Motiv atm to try and figure it out.

 

[PaulKendall]

Do you guys have these in stock now? I may or may not need one yet. Trying to figure out a trim variance between banks. Was headed towards PI rail but we will see in the next day or two hopefully.

I have a forward facing manifold I'd sell..

 

[pysical]

I have a forward facing manifold I'd sell..

That is probably out of my budget. I am mainly just getting a new manifold so it has the PI built into it and I don't have to worry about another set of gaskets going bad.

 

[PaulKendall]

Its is definitely more hassle, but if you do some legwork it would be cheaper, to about the same price. But bms has made it super easy and have a great price, but forward facing looks so great.