Map switch boost levels

[Emil__123]

Can someone tell me how to use map switch for only different boost levels ?
I don’t want Flexfuel or anything only different boost. I have a map that is good but right now I adjust boost with gfb3 and want to have one map for 28psi and one for 15psi but can’t figure it out.

 

[carabuser]

If the gfb3 controls boost then you wouldn't be able to do anything with boost target from MHD map switching.

 

[Emil__123]

Yes my bad. I want to ditch the gfb3 and control boost with the dme instead. I just dont understand how to use different boost levels per map in tunerpro

 

[carabuser]

Each map slot has a different load target table. You would just modify that to get the desired boost.

 

[yalmp]

Each map slot has a different load target table. You would just modify that to get the desired boost.

does it matter what map I set as map 1? Considering some tables such as the full wgdc base table etc are only in map 1, should that be my low boost map? or high boost, or map i mainly drive on? or does it not matter?

 

[carabuser]

does it matter what map I set as map 1? Considering some tables such as the full wgdc base table etc are only in map 1, should that be my low boost map? or high boost, or map i mainly drive on? or does it not matter?

No, doesn't matter, anything not map specific so will apply to all slots. The wastegate base table doesnt need to be map specific because it has an axis for boost target and airflow request.

 

[yalmp]

No, doesn't matter, anything not map specific so will apply to all slots. The wastegate base table doesnt need to be map specific because it has an axis for boost target and airflow request.

okay thank you!