Latest activity
-
seb.apprenti replied to the thread Rear axle drive 3.73.The 8hp70 would be ideal, that's true... but there are some modifications to be made that I don't want to make. The 8hp45 fits without... -
seb.apprenti replied to the thread Rear axle drive 3.73.Hi Omar. It's a flange with 4 screws. Here's the part number: 33107566179 I have the impression that the 335i output shafts can be...
-
you are right. I can´t answer your question. Sorry. Just wanted to give you the hint that with a DCT or 8HP (does not need to be a 70)...
-
TThunderstorm1250 replied to the thread Low pressure fuel drop. Eventual 29DC.Are you certain your 2nd lpfp pump is energizing? Are you using a relay and hobbs switch or something tp energize it? The secondary...
-
TThunderstorm1250 reacted to baronmellick's post in the thread Low pressure fuel drop. Eventual 29DC with
Like.
Hello everyone. A couple of months ago I did a single turbo swap and manual swap on my 335. For the low pressure setup, I did a PFS... -
Wanted to do something different and I love the e92 m3 gt4 factory race cars. Yes I know this isn’t an M3. I don’t care frankly. Cars... -
-
Hello everyone. A couple of months ago I did a single turbo swap and manual swap on my 335. For the low pressure setup, I did a PFS... -
Seb335i replied to the thread CarAbuser's DCT Tuning Services - GTS Flash for the Z4, 135i and 335i..Since it’s the M3 GTS tune modified for the 335i, I assume there must be a way to enable the M display. I already have an M cluster. -
pbondar replied to the thread My take on a Mr.5 intake.The issue….possibly is that the fresh air inlet may impede the flow…you’ll never really know without putting it on a dyno before and... -
Hydra Performance replied to the thread Rear axle drive 3.73.@seb.apprenti Do you have a threaded nut @ the diff input or a 3-bolt flange? -
AHello everyone I'm trying to tune my M2 N55, but I have a throttle closure from around 2600 rpm, yet the boost and pre-boost seem to...
-
Ttobi01 replied to the thread My take on a Mr.5 intake.Inspired by your results, I want to try a different route. I want to keep as mucho oem look as possible, therefore the filter inside the...
-
-
SSgop335 replied to the thread N54 STFT2 and Lambda wonky after tune options reset.most likely a hardware issue, not mhd+. Bank 2 not getting enough fuel and/or o2 sensor. Just looking at the color of the plug helps...
-
JohnDaviz replied to the thread Rear axle drive 3.73.you are right. I can´t answer your question. Sorry. Just wanted to give you the hint that with a DCT or 8HP (does not need to be a 70)... -
seb.apprenti replied to the thread Rear axle drive 3.73.I understand your point of view... my 6hp21 is suitable for my use... but it won't hold the torque sufficiently... on the other hand...
