Latest activity
-
Wwhyzee125 replied to the thread Need help with intermittent codes/warm start issue.This is very helpful, thank you! It looks like a good next step will be to pull the intake manifold, double check the seal on my barb...
-
Wwhyzee125 reacted to ktb_e92's post in the thread Need help with intermittent codes/warm start issue with
Like.
I see, I'm assuming you used some sort of thread sealer for that barb and capped off the original 1/8" port?..unless you drilled a... -
ktb_e92 replied to the thread Need help with intermittent codes/warm start issue.I see, I'm assuming you used some sort of thread sealer for that barb and capped off the original 1/8" port?..unless you drilled a... -
Wwhyzee125 replied to the thread Half n half inlet setup.That's the route I ultimately want to go. I want to ditch my DCIs for a Mr. 5/vasillalov intake and possibly also run the front inlet to...
-
WI have a friend who ran a setup like that on his upgraded twins before going single-turbo. Like what you're describing, his 2" rear...
-
Wwhyzee125 replied to the thread Need help with intermittent codes/warm start issue.There's a barb drilled in the intake manifold and running a 1/4 inch vacuum line to the BOV.
-
henrydavison replied to the thread Stalling at initial Acceleration and Stutters at Low RPM B58.No Codes -
ktb_e92 replied to the thread Need help with intermittent codes/warm start issue.What is your vacuum line setup between the intake manifold and the BOV?
-
Hello. This is my first post. I have an N54, 6MT, INA0S custom bin. I am looking for a way to change the throttle opening or... -
Mmattg replied to the thread N54 exhaust camshaft upgrade.Sure we message already on messenger FYI We Dynoed the car at 570 then 595whp by virtual after cam unfortunately the night before real...
-
EPOXY54 replied to the thread N54 exhaust camshaft upgrade.Hey Mattg, How can I contact you? Thanks -
ShocknAwe replied to the thread Stalling at initial Acceleration and Stutters at Low RPM B58.Codes? -
Ddesmo11 replied to the thread Half n half inlet setup.Thanks guys! If only Mr. FedEx man would hurry the F up!
-
I have a 2017 M240i and I replaced the following: Vanos Actuators and Reset Adaptations, PCV Diaphram, and Fuel Tank Breather Valve. The...