Latest activity
-
oVeRdOsE replied to the thread Walbro 450 on Pump Gas.no, there's no overpressure with this, flow is greater so requested pressure remain stable. I dont have access to corn fuel, and I... -
Zachair Paharsingh replied to the thread 6MT to 8HP/DCT.Its been a long time since… the car has msd81 now, but I would need to get an 335is dct rom to get it configured to work with and send... -
CCruizinmax replied to the thread FS $800 Xona Rotor turbo xr9567 ceramic ball bearing, vband.Sent you a DM. @Breakmywalletct
-
Ccampkillyourself replied to the thread Walbro 450 on Pump Gas.That was my plan, I was wondering if it would cause any issues though considering I only have access to pump gas in canada, I know guys...
-
oVeRdOsE replied to the thread Walbro 450 on Pump Gas.sure. DIY is easy, Ill suggest to keep the bucket and get the blackmarket 90° fitting. When you say it's dipping, did you log and...
-
Oornicar replied to the thread Swap 188mm auto pumpkin for 215mm? Diff cover options?.Hi Calvinismo! Thanks for your feedback. I have sometimes a strange hard clunk in the rear since a loooong time now. It reduced after i...
-
Oornicar reacted to CalvinNismo's post in the thread Swap 188mm auto pumpkin for 215mm? Diff cover options? with
Like.
I have run the 215 axles on a 188 diff’ for 10,000+ miles on the the wife’s 125i, no issues. What’re you thinking of doing @ornicar? -
CHey guys, Just replaced my hpfp and noticing my lpfp is pressure is dipping, car sat for years with almost a full tank i believe the...
-
wheela reacted to Pete.J's post in the thread Has anyone else noticed the throttle tables in the MHD S55 XDF are broken? with Like.
The defined tables were incorrect, I discovered the correct tables, and defined them and this all working well, now. Thanks for your... -
Pete.J replied to the thread Has anyone else noticed the throttle tables in the MHD S55 XDF are broken?.The defined tables were incorrect, I discovered the correct tables, and defined them and this all working well, now. Thanks for your... -
Eeasy60 replied to the thread BimmerFab VS Jack Fabrication N54 Single Turbo Kit Questions.I checked, and Jack Fab has all 5 star but no reviews (I can find at least) for the E60 Turbo Kit. And BimmerFab has 2 negative reviews...
-
Breakmywalletct replied to the thread FS $800 Xona Rotor turbo xr9567 ceramic ball bearing, vband.hm about this idk how to message i see u logged on today i comented on your profiel. -
CalvinNismo replied to the thread Swap 188mm auto pumpkin for 215mm? Diff cover options?.I have run the 215 axles on a 188 diff’ for 10,000+ miles on the the wife’s 125i, no issues. What’re you thinking of doing @ornicar? -
Oornicar replied to the thread Swap 188mm auto pumpkin for 215mm? Diff cover options?.Hi, since all this time is it always OK with your 188 diff? Do the 215 CV axles are Ok (they don't developp noises or clunks)?
-
AAxisKey replied to the thread Has anyone else noticed the throttle tables in the MHD S55 XDF are broken?.You've gone through all the right steps in adjusting the throttle mapping, but the lack of response to your changes suggests that the...