Is the Y axis on WGDC base table the boost set point in absolute or gauge pressure? It is expressed in units of bar right?
The stock X axis for WGDC is set low so if I see nearly 500g/s (WGDC Req g/s) in the actual log then should I add further columns to the X axis to make it extend to 500 or will it extrapolate?
Are the X axis on PID tables the error term (demand - actual)?
I have tried to read V8Bait’s tuning sheet but these are somethings I have not understood.
If I want to disable PIDs then should I make the adder table zero? I think I have read this somewhere here. Thanks for your help.
The stock X axis for WGDC is set low so if I see nearly 500g/s (WGDC Req g/s) in the actual log then should I add further columns to the X axis to make it extend to 500 or will it extrapolate?
Are the X axis on PID tables the error term (demand - actual)?
I have tried to read V8Bait’s tuning sheet but these are somethings I have not understood.
If I want to disable PIDs then should I make the adder table zero? I think I have read this somewhere here. Thanks for your help.
