self tune M2 N55

[agron25]

Hello everyone
I'm trying to tune my M2 N55, but I have a throttle closure from around 2600 rpm, yet the boost and pre-boost seem to match, right? Where do I have a torque limiter table? Because I feel like I'm limited to 500nm on the monitoring screen.
thanks
my log
Any ideas?

 

[mkr]

If by monitoring screen you mean the sport display on the car, I'm pretty sure its artificial but I could be wrong. If you are using tunerpro, make sure your transmission torque tables are set to a high value (like 900), and look at the load to torque tables to see if you have them set too low. In my table I kept it stock except for the last two rows that I rescaled to 180 and 220 load with higher values and I'm able to push 27psi.

 

[agron25]

Hello, thanks for your reply.
Yes, I did raise the torque safety, I set it to 800 nm for the moment, because I'm aiming for 1.5 bars / 22 psi. I also played with the KF_RFMAXATL_KR table, but it didn't give good results. However, with the KF_RFMAXHDP table, I can set my target pressure as I want. For the screen, I found the solution; I had to change the values in the file in KF_EDA_ANZ_SPORT_MDK_IST. Now, full E85, I'm limited by the injectors, I'm going to change them to S63 eur5 injectors.