Need help finding a intake duct block off

derekgates

Lieutenant
Feb 23, 2018
740
375
0
NW FL
derekgates.us
Ride
2011 335is
@Mikejones1208 @derekgates I went ahead and had 3 sets made for test fitment, they should arrive by the end of the week. It will be a two piece setup as I wanted to avoid a single larger cover to keep shipping, packaging and manufacturing costs down since a single plate can be flipped to fit the opposite side. Made in the USA from 2mm 6061 Aluminum with an expected sale price of $45 for a set + shipping. Started by 3D Scanning the stock plastic "snorkel?" to get accurate dimensions quickly and to verify design fitment. While one push lock would probably be sufficient I opted to add an ear that can go under two of the bolts that attach the bumper shown below in red. I'll let you know when they are in and send some photos of them mocked up on my car. Let me know if there's anything else you guys can think of. I'm more than happy to make an idea come to life if it makes sense.

View attachment 50564

Simplified 3D Scan

View attachment 50565

Reference geometry then used for plate design inside of Solidworks.

View attachment 50566

View attachment 50567

Wow, just wow. I am sorry I didn't reply sooner but I somehow didn't get a notification from your mention!

I am down for this! In awe of the R&D.