Hi Guys,
I was looking for a data display that should show me all the data I need, Boost, Lambda, EGT, EMAP and so on.
But none display on the marked matched my needs, additionally I need a boost controller, the GFB one is a good choice with scramble boost. But it’s an additional device on the dashboard.
So, I found the CanChecked display which is a CanBus based display as Awron or AK-Motion, but totally flexible for your personally needs and with four additionally IO´s.
You can configure up to ten pages with Widgets you want, to show all the data you need.
And it has an additional boost controller option with two scramble boost options and a dynamic duty option. Furthermore, you can reduce the boost by gear, or up to five valves of your choice.
Until now there is not specific frame for the display to fit in a e82 or e9x, so I have built my own. But I think they will release specific frames in the future.
I also connected an AEM Lambda to Can, EMU EGT to Can module, and an EMAP sensor, all other data came from CanBus.
I will continue this thread from time to time.
CanChecked display with Boost controller
Display frame design
Prototype frame
Start screen
Widgets configuration
Widgets on display
DynDuty configuration with boost by gear
Junctionbox for the display and the Addons
I was looking for a data display that should show me all the data I need, Boost, Lambda, EGT, EMAP and so on.
But none display on the marked matched my needs, additionally I need a boost controller, the GFB one is a good choice with scramble boost. But it’s an additional device on the dashboard.
So, I found the CanChecked display which is a CanBus based display as Awron or AK-Motion, but totally flexible for your personally needs and with four additionally IO´s.
You can configure up to ten pages with Widgets you want, to show all the data you need.
And it has an additional boost controller option with two scramble boost options and a dynamic duty option. Furthermore, you can reduce the boost by gear, or up to five valves of your choice.
Until now there is not specific frame for the display to fit in a e82 or e9x, so I have built my own. But I think they will release specific frames in the future.
I also connected an AEM Lambda to Can, EMU EGT to Can module, and an EMAP sensor, all other data came from CanBus.
I will continue this thread from time to time.
CanChecked display with Boost controller
Display frame design
Prototype frame
Start screen
Widgets configuration
Widgets on display
DynDuty configuration with boost by gear
Junctionbox for the display and the Addons
Last edited:
