I just got my car back together after some issues. I took it out for a little casual drive. I wanted to see how everything was going to hold up so I did a slow pull just to gradually check things. In 4th gear on the highway giving it just enough throttle to start building boost, it would go up to about 15 and then just dump it all. I only did this twice and recorded it once. I noticed the boost target goes to 0 and wasn't sure if this is something that is mechanically or electronically controlled? Prior to hooking up the reflex my car would idle fine on startup, now it runs a little rough then clears out. I was also not getting any codes but now I get 2 that I can't figure out.
Log: https://datazap.me/u/pysical/boost-cutting-out?log=0&data=3-21
Codes:
2D2E - DME: Throttle-valve angle - intake-manifold vacuum, correlation
2d33 - DME: Absolute-pressure sensor, intake manifold: signal
I feel like it is related to the Reflex but I am not sure and just wanted to check with people here on things to possibly check before I go removing it.
Thanks!
EDIT:
This tune I have used in the past with no issues. Its a bottom mount 6466 single turbo setup on 93.
Log: https://datazap.me/u/pysical/boost-cutting-out?log=0&data=3-21
Codes:
2D2E - DME: Throttle-valve angle - intake-manifold vacuum, correlation
2d33 - DME: Absolute-pressure sensor, intake manifold: signal
I feel like it is related to the Reflex but I am not sure and just wanted to check with people here on things to possibly check before I go removing it.
Thanks!
EDIT:
This tune I have used in the past with no issues. Its a bottom mount 6466 single turbo setup on 93.
Last edited: