PCV Setp Issues

[@juan35i]

VTT Cast aluminum valve cover
VTT dual catch cans
Vacuum relief valve
Blocked head ports


Currently running this catch can setup but having these codes. What am I missing? VTT sent me this diagram so I followed with it. I have not installed a breather cap. Is that the issue? Thanks in advance

 

[JohnDaviz]

I think the Code 2D2E is the source of your issues.

I don´t know where Vacuum is connected in that setup but your throttle valve control is not working as expected because of a vacuum leak somewhere in that area.

 

[@juan35i]

On the low side I have a vacuum line going to the throttle body with a check valve

 

[Reformatt]

Might want to add a check valve before your VTA filter. I also had to adjust the vacuum relief spring..I snipped a bit of mine..I noticed excessive vacuum when taking the oil cap off…Was pulling on my palm like a new gf . Before fine tuning the vacuum/crankcase pressure I was constantly replacing valve cover gaskets path of least resistance I assume..

There are many configurations to achieve the desired results. Kinda dirty but that is how mine is set up.

After your sorted I would reset some adaptations an hopefully some of those codes will sort themselves out