Any Sim Racers on here?

  • Server Time was corrected, might see weird timestamps for a few hours.

AzNdevil

Corporal
Nov 4, 2016
214
Hong Kong
ok so.... i bought a set of e9x manual pedals and the accelerator module...

IMG_20170620_231834.jpg


did a half assed mock up in 3d using tinkercad because its easier than sketchup (at the time)
IMG_20170623_112931.jpg


bought a bunch of stuff off alibaba and ebay
IMG_20170708_190141.jpg

put the frame together, mount the pedals
IMG_20170710_030929.jpg

dremel an actuator fitting to go over the brake pedal
IMG_20170720_021648.jpg

drill the angled aluminium brackets to mount the clutch master cylinder
IMG_20170722_005831.jpg

reused the old bracket from the original clutch master to connect the new clutch master
IMG_20170723_210614.jpg


then i realized the pedals arent angled enough when i put the accelerator pedal next to them (didnt take a pic but the brake pedal is sitting close to the bottom of the accelerator pedal when put together)
IMG_20170723_210802.jpg


thats all the progress for now, i have a few oil pressure senders, two pull clutch slave, a bunch of an3 fittings and crimped an3 brake hoses and two oil pressure gauges sitting here until i get around to mounting the pedals properly
20590810_10155043209669615_1763520918_o.jpg


i havent decided if i will keep this design as the 14mm rod might not be able to take the force from braking... and i have to drill more holes to more the pedals closer to the clutch master to they angle out more....
 
Last edited:
  • Like
Reactions: doublespaces

doublespaces

Administrator
Free Vendor
Oct 18, 2016
7,046
AZ
I have nothing to compare this to as this is totally new to me, but it looks awesome!
 
Top